The Challenges to Swim Spa Covers

Swim Spas represent special obstacles when it concerns covering them.
We can all agree that the swim spa has to be covered when not in use for all the same factors a hot tub requires a cover. The challenge is that because of the length of the swim spa and the height of the sides, eliminating and replacing the cover can be a lot more difficult.
Getting a brand-new swim spa is an amazing occasion in life. You’re looking forward to the exercise you’ll receive from using it. Possibly you’re a little relieved to have lastly selected from the various designs you looked at. At any rate, you most likely weren’t believing much about the cover you would use.
Usually, the cover that gets back with your new purchase will be a four section rigid foam filled cover that will split in the center and go off both ends.
No big deal.
Up until it begins to get heavy.
Which it always does.
Every stiff foam filled Swim Spa Cover ever made ends up the same way and it is not the fault of the user. It’s a design defect. Built in obsolescence because as soon as it is positioned in use over the warm water in your swim spa it is unavoidable.
It’s not from rain, so having a taper won’t make any distinction. In fact you might have it under a roof and the cover will still get heavy.
The factor is the steam from the water. The particles of steam are really small as they rise from the water surface area. They make their method into the little fractures and crevices in the foam. Then as the steam cools it forms back into a liquid and ends up being trapped in the cover.

It occurs slowly and on a Swim Spa Cover which is made of private sections, at varying speeds. So ultimately you’ll notice a couple of of the areas are really getting heavy. The bar lifters on the ends of the swim spa aren’t much help because you still need to raise that heavy cover back up onto the spa which is a lot higher than a regular spa.
This is why SpaCap.com developed a different style for their Swim Spa Covers
Instead of using a number of foam panels to develop Swim Spa Covers that will ultimately wind up in some landfill, they designed one that uses air chambers that don’t suck up moisture.
In fact SpaCap.com Swim Spa Covers are lightweight, insulate much better, won’t blow away in a wind storm or be harmed by snow or hail.
Covered with Sunbrella Marine material, these covers won’t fade, or fall apart at the seams either. So if you own a swim spa, and you plan to keep using it daily, SpaCap.com has the Swim Spa Cover for it.
If you’re not ready to purchase today, bookmark this site so you can find it again when you’re ready!

Leave a Reply

Your email address will not be published. Required fields are marked *